|
|
Suggested
assembling sequence:
Read the assembling instructions considering the proposed sequence.
1) Join legs to frontal and lateral strips, in the indicated places, being careful to
keep the set square, centring the frontal and lateral strips with regard to the center of the legs.
2) Join all 5 guides to each of two triangular lateral panels, that will be use
as support of the oblique panel where the chips will fall.
3) Join the triangular lateral panels, to both sides of the interior side of the furniture.
Now you can paint the structure.
4) Join the thin strips to each of 4 interior oblique panels, which will guide
chips in their fall.
5)
Join the strips that form the conduit of the old woman, and also
join them
to the biggest-sized oblique panel
at
its
smooth part (where there are no strips), centred. Now you can paint the
exterior parts, the back one
(where is
the conduit of the old woman) and if
you wish, the part of the conduits of the
chips.
6) Put
all 4 interior panels obliquely
and
correct their inclination
if necessary, in order
to avoid light passing between them
and the frontal strips, prevent the chips from falling down,
Also look carefully that the
top part of the panel does not exceed the final size
of the legs (up).
Once done the necessary changes, stick.
7) Fix the small mills to the square table with holes.
Verify they turn
freely.
8) Assemble the back panel (old woman´s or
sun), joining the wood
to the sheet, (the wood must have a conduit where the chip can fall freely) and the old woman to the sheet, verifying the normal fall of the
chip. If necessary, bend out the lowest part of the mouth so that the chip slips
easily. It is better to paint the sheet before the old woman is fixed. Also, you
can now paint the wings.
9) Put the top table with holes and verify the position of the holes regarding the guides
so that the chips fall down normally.
10) Assemble both lateral panels, joining the wood to the sheet. It is suggested
to previosly paint the exterior wood and the interior sheets.
11) Put the back panel, making it run forward the table with holes, and put
the wings. Once verified, fix the panel with hole to the legs of the structure.
(So that then, the protective sheet covers the heads of the screws)
12) Join the lateral panels with the back panel (old woman´s)
13) Join the protective sheet to panel with holes.
14) Join the set of the lateral panels to the back. Now you can screw the toad.
When we say "'join", whenever it is possible, it is recommended to screw, or to fix and to stick.
For a better completion, the screws with visible heads, can be drilled with a wick of 8/10 mm to conceal the heads,
and, then putting blockheads, and sanding.
October, 2002
Translated by ycristal@yahoo.com
Reproduce mentioning www.juegodesapo.cjb.net
